RPM 80902 Wheelie Bar Bumper Mount (Black) For Rustler, Stampede

RPM Rear Bumper Mount "Wheelie Bar Mount" Replaces Traxxas #3677     for Slash & Rustler 2WD Body Post Extensions (Moves body posts back by 3" - perfect for drag race bodies) After hearing numerous requests to look into the rear bumper mount on the Traxxas Slash, RPM found several issues that could use the RPM touch. Those same problems were encountered on e-Rustler, e-Stampede, and Bandit vehicles as well, using the stock wheelie bar mount. The problem – the stock mount uses only a single screw on the gear cover side to hold the mount in place. That causes a hinge effect under rear impacts causing the slotted area holding on to the rear skid plate to pop off after an impact, leaving the stock bumper/wheelie bar mount hanging under the chassis. The RPM solution… An all-new bumper mounting system that eliminates all of the problems encountered with the stock version. The RPM rear bumper/wheelie bar mount has two mounting holes on the gear cover side and three on the motor side – that’s two additional mounting points to eliminate that annoying hinge effect mentioned above. The additional mounting screws help disperse impact energy into the transmission case over more surface area, reducing the possibility of damaging the case significantly! The new RPM mount design means no more slotted parts hanging below the rear skid plate – ever! RPM's mount tucks up quite nicely behind the skid plate for better rear end ground clearance. Thei r rear bumper/wheelie bar mount fits a wide range of vehicles too. It fits all versions of the Traxxas Slash 2wd, electric Stampede, electric Rustler, and Bandit including VXL, XL-5 and legacy versions.

Returns Accepted for this item if it's within 30 Days